V6204 Cid, 3.4L, Dual Twin Cam, Manual Transmission
Required Parts
A/C refrigerant line O-Rings 4
Exhaust Gasket set 1
Transmission output seals 2
Clutch pressure plate 9 11/16″
Kevlar/Kevlar clutch disk 9 11/16″
Throw-out bearing 1
Optional Parts
1.5″ hose clamps Coolant/Heater system 8
2.25″ hose clamps Coolant/Engine system 4
Dogbone and Bracket 1
High volume fuel pump (51psi@41GPH) 1
Aluminum subframe bushings (Pre1988 models) 1 set
Coil pack bracket 1
Modified thermostat housing/ coolant fill (core REQUIRED) 1
Steel braided A/C hose, includes weldon fittings 1 set
Steel braided fuel hose, includes fittings 1 set
Throttle cable assembly bracket with Cruise Control mount 1 Water pump inlet hose 1
Wiring Loom Engine/Transmission/Sensors/ECM 1
Wiring schematics (customized CAD diagrams) 1
Modified Shifter Cable Mounting bracket (4Speed) 1
Modified Clutch Armature 1
Modified Fuel Lines 1 set
Disable Power Steering Pump and Plug 1
Move Torque Armature to Transmission 1
Air Intake Hose 1
Exhaust System 1
Gas Springs for Decklid 2
Labor
Remove and Replace engine assy.
Engine Bay Preparation subframe, transaxle assy, corrosion control, and painting
Remove R/H side Deck Hinge
Cut Battery Box for ECM
Remove old Torque Bracket on Strut Tower
Engine Bay Insulation Installation
Engine assembly installation onto Fiero Cradle
Engine Installation into vehicle includes electrical, mechanical,
plumbing, and transaxle connection.
Charge and inspect A/C system
Service transmission change fluid w/ new filter